HP StorageWorks XP Remote Web Console Software - Manual (Page 101)

Paths panel, check the setting on the Path Setting panel, and then apply the setting to the array.
You can also change the setting of the paths by each external volume on the Path Setting panel.
CAUTION: You cannot delete all the current alternate paths to substitute newly-added alternate
paths for them in one operation. To replace all the current alternate paths with newly-added alternate
paths, you need to perform more than two operations and leave at least one current alternate path
setting when you perform the first operation. For the detailed procedure, see
“Replacing all the
alternate paths with newly-added alternate paths” (page 99) .
NOTE: Use the Add Paths window to add paths to multiple external LUs at one time. However,
path settings might not be applied because of the current path setting of each volume. After setting
paths in the Add Paths window, check whether or not the new path settings can be applied in the
Path Setting window for each external LU. If the setting cannot be applied, the setting from the
Add Paths window does not appear on the Path Setting window. The setting from the Add Paths
window also does not appear in the Preset list or in the LU Operation pane.
Figure 54 Add Paths window
•
Port
Local array ports. After selecting a port, you can add paths. One of the following icons appears
for each port:
Description Icon
Port in Standard mode.
Port in Initiator/External MIX mode.
•
Selected Paths
Paths that are added as ports that configure alternate paths. WWNs identify ports on the
external array. Nothing is displayed when you initially access the Add Paths window.
•
Unselected Paths
External array ports (WWNs) that can configure the path connecting with the local array port
selected in the Port list. Select WWNs from this list to add as alternate paths.
•
Set
Moves WWNs selected in Unselected Paths to Selected Paths.
•
Release
Moves WWNs selected in Selected Paths to Unselected Paths.
Adding alternate paths by selecting multiple external LUs (Add Paths) 101