HP StorageWorks XP Remote Web Console Software - Manual (Page 158)

the following table, see the manuals of the Sun StorageTek 2540 and set the parameters
appropriately for the connecting configuration.
Table 29 System parameter settings for connecting Sun StorageTek 2540
Parameter setting Parameter
Windows 2K non Clustered DMP host type
Alternate paths for connecting Sun StorageTek V2X2
If you connect a Sun StorageTek V2X2 as an external array, specify 0 for Alternate Path when you
map external volumes. Do not add any alternate paths after you finish mapping external volumes.
Connecting EMC CLARiiON CX Series
System parameter settings for connecting EMC CLARiiON CX Series
When you connect an EMC CLARiiON CX series as an external array, set the system parameters
of the EMC CLARiiON CX series according to the following table. For the system parameters that
are not in the following table, see the manuals of the EMC CLARiiON CX series and set the
parameters appropriately for the connecting configuration.
Table 30 System parameter settings for connecting EMC CLARiiON CX Series
Parameter setting Parameter
CLARiiON Open Initiator type
2 Failover mode
Notes on Connecting EMC CLARiiON CX Series
RAID-0 volumes on the EMC CLARiiON CX series are not supported.
System Parameter for Connecting EMC Symmetrix Series
When you connect an EMC Symmetrix series as an external storage system, set the system
parameters of the EMC Symmetrix series according to the following table. For the system parameters
that are not in the following table, refer to the documentation of the EMC Symmetrix series and
set the parameters appropriately for the connecting configuration.
Table 31 System Parameters for Connecting EMC Symmetrix Series
Parameter Setting Parameter
Enable SC3 flag
Disable SPC2 flag
System parameter settings for connecting IBM DS4000 Series
When you connect an IBM DS4000 series as an external array, set the system parameters of the
IBM DS4000 series according to the following table. For the system parameters that are not in the
following table, see the manuals of the IBM DS4000 series and set the parameters appropriately
for the connecting configuration.
Table 32 System parameter settings for connecting IBM DS4000 Series
Parameter settings Parameter
When alternate paths are connected to different clusters
on the DS4000 series side: Linux host type
158 Notes on connecting external arrays