HP StorageWorks XP Remote Web Console Software - Manual (Page 118)

Before deleting the external LU mapping, notice if any of the following are true:
•
Whether or not the execution of any application (for example, XP RAID Manager) that is using
the command device is in progress.
If any application using an external LU command device is executing, stop the application.
•
Whether the Disconnect Subsystem or Disconnect Volumes command was executed.
All data in cache memory must be written into the mapped external LU using the Disconnect
Subsystem or Disconnect Volume command. For more information about the Disconnect
Subsystem and Disconnect Volume commands, see
Disconnecting external arrays or LUs .
•
The volume is part of a LUSE volume.
•
A path is set.
•
The volume is configured as part of an XP Continuous Access, XP Continuous Access Journal,
XP Business Copy, or XP Snapshot pair.
•
The volume is set as a reserved LU for XP Business Copy or XP Auto LUN.
•
The volume is set as a pool-VOL.
If any of these conditions are true, you cannot delete the external LU mapping.
1.
In the LU Operation pane, select the external LU group number in the Device tree. Information
about the external LU mapped as an internal LDEV appears in the Device list.
2. In the Device list, right-click the external LU for which you want to delete the mapping, and
select Delete LU.
Settings appear in blue italics in the Device list, and they appear in the Preset list. To check
details regarding intended changes, right-click the setting in the Preset list, and select Detail.
To cancel settings, right-click the setting in the Preset list, and select Delete.
NOTE: The maximum number of external LUs you can set at one time is 256.
3. Click Apply. A confirmation message appears.
If you already stopped the application, go to step 4. If you have not stopped the application,
click Cancel, stop the application, and retry the operation.
4. Click OK. A confirmation message appears.
5. Click Yes or No.
If you click Yes, a confirmation message appears.
If you click No, a warning message appears. To execute the Delete LU operation without
writing data in the local array cache memory to the external LU, click OK. To cancel the
operation, click Cancel. If you click OK, a confirmation message appears.
NOTE: If you click OK in response to the warning, the Delete LU operation is performed,
but data in the local array cache memory that is not yet written to the external LU might be
lost.
6. Click OK. The external LU whose mapping is deleted is removed from the Device list.
If errors occur, failed settings and error codes appear in the Preset list. To check error messages,
right-click the failed setting, and select Detail.
118 Configuring external LUs