HP StorageWorks XP Remote Web Console Software - Manual (Page 142)

A Notes on connecting external arrays
Connecting Thunder 9500V subsystems
System parameters for connecting Thunder 9500V subsystems
Table 12 (page 142) explains whether to specify system parameters when making settings for ports
on the Thunder 9500V subsystem.
Table 12 System parameter settings (Thunder 9500V subsystems)
Parameter setting Parameter Pane name
Start Attribute System Startup Settings
Specify this parameter when the Thunder 9500V subsystem
is in the one-controller configuration. • Single Mode
Specify this parameter when the Thunder 9500V subsystem
is in the two-controller configuration.
NOTE: Be sure to specify that Data Share Mode will be
used.
• Dual Active Mode
Do not specify this parameter. •
Hot Stand-By Mode
You can either specify this parameter or omit specifying this
parameter. Delay Planned Shutdown Common 1
You can either specify this parameter or omit specifying this
parameter. SCSI Fibre Channel
Common Options OPTION 1
You can either specify this parameter or omit specifying this
parameter. SCSI Fibre Channel
Common Options OPTION 2
Set this parameter to Reset of occurred. Operation if the processor
failure occurs Data Striping
Set this parameter to ON. Command Queuing Mode Inquiry Setting
Keep this parameter as HITACHI (default), and do not
change. Vendor ID
Keep this parameter as DF600F (default), and do not
change. Product ID
You can either specify this parameter or omit specifying this
parameter. ROM Microprogram
Version
You can either specify this parameter or omit specifying this
parameter. RAM Microprogram
Version
You can either specify this parameter or omit specifying this
parameter. WEB Title
Reset/LIP Mode Port Type
You can either specify this parameter or omit specifying this
parameter. •
Reset/LIP Mode
(Signal)
You can either specify this parameter or omit specifying this
parameter. • Reset/LIP Mode
(Process)
You can either specify this parameter or omit specifying this
parameter. •
LIP Reset Mode
You can either specify this parameter or omit specifying this
parameter. RS232C Error Information
Outflow Mode Controller Option
142 Notes on connecting external arrays