HP StorageWorks XP Remote Web Console Software - Manual (Page 110)

Figure 59 Disconnect array and check paths and restore volume commands
The selected external array appears in blue italics in the LU list and Device list, and appears
in the Preset list. To check details on the intended operations, right-click the setting in the Preset
list, and select Detail. To cancel settings, right-click the setting in the Preset list, and select
Delete.
3. Click Apply. A confirmation message appears.
4. Click OK.
The Ex-Dev. Status column in the Device list changes to Cache Destaging. When XP External
Storage finishes writing data from cache to the external LU, the Ex-Dev. Status column changes
to Disconnect.
If errors occur during disconnect operations, failed settings and error codes appear in the
Preset list. To check error messages, right-click the failed setting, and select Detail.
CAUTION: To access the external array after executing the Disconnect Subsystem command, you
must execute the Check Paths & Restore Vol. command.
Disconnecting external LUs individually (Disconnect Volume)
1. In the LU Operation pane, select an external LU group number in the Device tree. Information
about external LUs in the selected external LU group appears in the Device list.
2. In the Device list, right-click the external LU you want to disconnect from the local array, and
select Disconnect Volume. The selected external LU group number in the Device tree and the
selected external LU in the Device list appear in blue italics. It also appears in the Preset list.
To check details on the intended operation, right-click the row in the Preset list, and select
Detail. To cancel settings, right-click the row in the Preset list, and select Delete.
3. Click Apply. A confirmation message appears.
110 Configuring external LUs