Ashcroft ATE-2 - Handheld Calibrator - Manual (Page 13)

11
The operator can program several parameters in the calibrator
which are further detailed in this manual. Programmable parame-
ters include:
• Date and time
• Owner name
• Auto off time
• Port selection
• Select Voltage (v) or current (mA) monitoring
• Enable/Disable 24VDC power supply
• Zero modules
• Tare
• Damping
• Percent error function
• Engineering units select
• User defined unit of measure
• Dual sensor mode
• Pressure or Temperature switch test mode
• Calibration of base unit
• Module calibration
• Datalogging via USB
• Datalogging to internal memory
• Transfer datalog to SD card
Owner name and base unit calibration functions are password
protected. The passwords may be obtained by contacting the fac-
tory or downloading the “HHC Secure” application from the web
site. “HHC Secure” will generate the HHC’s unique pass codes
based on user input of the base unit serial number. Make a note
of these pass codes
Owner Pass code_______________________________
Calibration pass code _________________________________
Quick-select modules are available for measuring a wide variety
of pressure and temperature ranges. They can be “hot swapped”
within the base unit while it is powered on without causing any
damage to the base unit or the module. “Hot Swap” refers to
installing or removing modules while the base unit is powered
on. The base unit will recognize the module and display the unit
of measure in which the module was originally calibrated and
labeled. Quick-Select pressure modules are available in accura-
cies from ±0.1% to ±0.025% of span.
SECTION 5 HOW TO OBTAIN PROGRAMMING
PASSCODES
SECTION 6 QUICK-SELECT MODULE
OVERVIEW
SECTION 4 BASE UNIT OVERVIEW CONT.
USB PORT SD CARD PORT
USB MICRO B
CONNECTOR