Ashcroft ATE-2 - Handheld Calibrator - Manual (Page 29)

27
Programming Owner Name (15 Characters max)
Press MENU key
Press DOWN or UP ARROW key to highlight “Setup…”
Press ENTER
Press DOWN or UP ARROW key to highlight “System”
Press ENTER
Press DOWN or UP ARROW key to highlight “Owner…”
Press ENTER
Owner Password screen appears. If the Owner Password is not
known, see section 5 to obtain owners password.
Press left and RIGHT ARROWs to position cursor beneath
desired character
Press UP and DOWN ARROWs to increment numeric characters
When the password is correct press ENTER
“Enter Owner name” screen appears
Note: If the incorrect password is entered, the HHC display will
show a message “Bad Owner PW”, and the user will be asked to
Retry or Abort.
Press LEFT and RIGHT ARROWs to position cursor beneath
desired character
Press UP and DOWN ARROWs to increment alpha and numeric
characters
When the Owner name is correct press ENTER
The HHC will save and exit to Measurement Mode.
The HHC has two programmable auto off timers designed to
maximize battery life. The “Power Off” timer will shut down the
HHC base unit completely after a user selected time. The “Back-
light Off” timer controls the backlight function only. It is possible to
have two different times programmed for these features. Selecting
the option “Never” for either function will disable the timer alto-
gether and the user must manually switch the base unit and back
light on/off by pressing the proper key.
Note: When the HHC base unit is powered via the USB port or is
auto datalogging, auto off timers are both disabled.
Program Auto Off Timers
Press MENU key
Use DOWN or UP ARROW to highlight “Setup”
Press ENTER
Use DOWN or UP ARROW to highlight “System…”
SECTION 15 b. ii. Programming Owner Name
Owner Password
00000
^
Enter to accept
Esc to cancel
Enter Owner Name
Joe Smith
^
Enter to accept
Esc to cancel
SECTION 15 b. iii Program Auto Off Timers
Ꮨƽ
Ꮨƽ