Allied Telesis AT-S63 - Manual (Page 177)

AT-S63 Management Software Menus User’s Guide
Section II: Advanced Operations 177
For example, if the switch has the static IP address 149.44.44.44 and
the management VLAN has a VID of 12, the upgrade process
automatically creates a routing interface with the same IP address and
names it VLAN12-0. It assigns the interface to the VLAN with the VID
of 12 and designates it as the switch’s local interface.
To upload the AT-S63 management software image from a master switch
to other switches in the same enhanced stack, perform the following
procedure:
1. From the Main Menu, type 8 to select Enhanced Stacking.
The Enhanced Stacking menu is shown in Figure 22 on page 86.
2. From the Enhanced Stacking menu, type 2 to select Stacking
Services.
Note
The “2 - Stacking Services” selection is only available on a master
switch.
The Stacking Services menu is shown in Figure 23 on page 88.
3. From the Stacking Services menu, type 1 to select Get/Refresh List of
Switches. The master switch polls the subnet for other enhanced
stacking switches in the same enhanced stack and displays the
switches in the Stacking Services menu.
4. Type 4 to select Download Image/Bootloader File.
The following prompt is displayed:
Remote switches will reboot after load is complete.
Enter the list of switches ->
5. Enter the number (Num column in the menu) of the AT-9400 Switch
whose software you want to update. You can specify more than one
switch at a time (for example, 2,4,5).
Note
The AT-S63 software is only supported on the AT-9400 Switches.
The following prompt is displayed:
Do you want to show remote switch burning flash -> [Yes/
No]
6. You can respond with Yes or No to this prompt. It does not affect the
download.