Allied Telesis AT-S63 - Manual (Page 273)

AT-S63 Management Software Menus User’s Guide
Section II: Advanced Operations 273
5 - ToS
Specifies a replacement value to write into the Type of Service (ToS)
field of IPv4 packets. The range is 0 to 7. A ToS value specified at the
policy level is used only if no value has been specified at the flow
group and traffic class levels.
6 - Move ToS to Priority
If set to yes, replaces the value in the 802.1p priority field with the
value in the ToS priority field on IPv4 packets. If set to No, which is the
default, the packets retain their preexisting 802.1p priority level.
7 - Move Priority to ToS
If set to yes, replaces the value in the ToS priority field with the value in
the 802.1p priority field on IPv4 packets. If set to No, which is the
default, the packets retain their preexisting ToS priority level.
8 - Send to Mirror Port
Copies the traffic that meets the criteria of the classifiers to a
destination mirror port. If you set this to yes, you must specify the
destination port by creating a port mirror, as explained in Chapter 8,
“Port Mirroring” on page 137.
9 - Traffic Class List
Specifies the traffic classes to be assigned to the policy. The specified
traffic classes must already exist. Separate multiple IDs with commas
(e.g., 4,11,13).
A - Redirect Port
Specifies the port where the classified traffic from the ingress port is
redirected.
B - Ingress Port List
Specifies the ingress ports to which the policy is to be assigned. Ports
can be identified individually (for example, 5,7,22), as a range (for
example, 18-23), or both (for example, 1,5,14-22).
A port can be an ingress port of only one policy at a time. If a port is
already an ingress port of a policy, you must remove the port from its
current policy assignment before adding it to another policy.
D - Egress Port
Specifies the egress port to which the policy is to be assigned. You can
specify only one egress port.
A port can be an egress port of only one policy at a time. If a port is
already an egress port of a policy, you must remove the port from its
current policy assignment before adding it to another policy.
6. After configuring the parameters, type C to select Create Policy.
The new policy is immediately activated on the specified ports.
7. To create another policy, repeat this procedure starting with step 3.