Allied Telesis AT-S63 - Manual (Page 325)

AT-S63 Management Software Menus User’s Guide
Section IV: SNMPv3 325
allowing you to save your changes. Allied Telesis recommends this
storage type.
Note
The Row Status parameter is a read-only field. The Active value
indicates the SNMPv3 User Table entry takes effect immediately.
12. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting an
SNMPv3 User
Table Entry
You may want to delete an entry from the SNMPv3 User Table. When you
delete an entry in the SNMPv3 User Table, there is no way to undelete, or
recover the entry.
To delete an entry in the SNMPv3 User Table, perform the following
procedure.
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 321. Or,
from the Main Menu type 5->5->5.
The Configure SNMPv3 Table menu is shown in Figure 126 on page
322.
2. From the Configure SNMPv3 Table menu, type 2 to select Configure
SNMPv3 User Table.
The SNMPv3 User Table is shown in Figure 127 on page 322.
3. From the SNMPv3 User Table, type 2 to select Delete SNMPv3 Table
Entry.
The following prompt is displayed:
Enter User (Security) Name:
4. Enter the User Name of the User Table entry you want to delete.
The following prompt is displayed:
Do you want to delete this table entry? (Y/N):[Yes/No]->
5. Enter Y to delete the user or N to save the user.
6. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.