Allied Telesis AT-S63 - Manual (Page 309)

AT-S63 Management Software Menus User’s Guide
Section III: IGMP Snooping, MLD Snooping, and RRP Snooping 309
Enabling or Disabling MLD Snooping
To activate or deactivate MLD snooping on the switch, perform the
following procedure:
1. From the Main Menu, type 6 to select Advanced Configuration.
The Advanced Configuration menu is shown in Figure 118 on page
296.
2. From the Advanced Configuration menu, type 3 to select MLD
Snooping Configuration.
The MLD Snooping Configuration menu is shown in Figure 122 on
page 306.
3. From the MLD Snooping Configuration menu, type 1 to select MLD
Snooping Status.
The following prompt is displayed:
MLD Snooping Status (E-Enabled, D-Disabled) :
4. Type E to enable MLD or D to disable it. The default setting is disabled.
A change to the status of MLD snooping is immediately implemented
on the switch:
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.