Allied Telesis AT-S63 - Manual (Page 216)

Chapter 11: Event Logs and the Syslog Client
216 Section II: Advanced Operations
5. Enter the number of the log output that you want to modify.
The Syslog Output Configuration menu is displayed, as shown in
Figure 68 on page 211.
6. Refer to “Creating a Log Output Definition” on page 210 for information
about the menu selections.
7. When you complete the modifications, type M to select Modify Log
Output.
The Configure Log Outputs menu as shown in Figure 67 on page 210
is redisplayed.
8. To permanently save your change, return to the Main Menu and type S
to select Save Configuration Changes.
Deleting a Log
Output
To delete a log output definition, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
2. From the System Administration menu, type 8 to select Event Log.
The Event Log menu is shown in Figure 63 on page 198.
3. From the Event Log menu, type L to select Configure Log Outputs.
The Configure Log Outputs menu is shown in Figure 67 on page 210.
4. From the Configure Log Outputs menu, type 3 to select Modify Log
Output.
The following prompt is displayed:
Enter output ID to delete [2 to 20] ->
5. Enter the number of the log output that you want to delete.
The following prompt is displayed:
Are you sure you want to delete output ID x? [Yes/No] ->
6. Enter Y for Yes or N for No and press Enter.
If you enter Y, the output ID you selected is deleted.
7. To permanently save your change, return to the Main Menu and type S
to select Save Configuration Changes.