Allied Telesis AT-S63 - Manual (Page 456)

Chapter 23: Multiple Spanning Tree Protocol
456 Section V: Spanning Tree Protocols
8. Enter the VLAN ID of the virtual LAN that you want to associate with
the MSTI ID. You can enter more than one VLAN at a time (for
example, 2,4,7) (To view VIDs, refer to “Displaying VLANs” on
page 485.)
The VLANs already associated with the MSTI ID are removed when
the new VLANs are added. The removed VLANs are returned to CIST.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Clearing VLAN
to MSTI
Associations
To clear VLAN to MSTI associations, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 152 on
page 420.
2. From the Spanning Tree Configuration menu, type 3 to select Configure
Active Protocol.
The MSTP menu is shown in Figure 162 on page 441.
3. From the MSTP menu, type M to select MSTI menu.
The MSTI menu is shown in Figure 164 on page 447
4. From the MSTP menu, type V to select VLAN-MSTI Association menu.
The VLAN-MSTI Association menu is shown in Figure 165 on page
453.
5. From the VLAN-MSTI Association menu, type 4 to select Clear VLAN
to MSTI Association.
The following prompt is displayed:
Enter the MSTI ID: [1 to 15] ->
6. Type the MSTI ID number and press Return.