Allied Telesis AT-S63 - Manual (Page 524)

Chapter 27: Protected Ports VLANs
524 Section VI: Virtual LANs
The prompt displays the ports of the VLAN.
13. Enter the port in the VLAN to function as the uplink port for the groups
in the VLAN. You can specify more than one uplink port.
The following prompt is displayed:
Enter Group Ports (4 - 11) ->
The prompt includes the ports in the VLAN, minus the uplink port
specified in the previous step.
14. Specify the ports of one of the groups of the protected ports VLAN.
This can be a few as one port or as many as all the remaining ports of
the VLAN. You can specify the ports individually (e.g., 2,3,5), as a
range (e.g., 7-9), or both (e.g., 2,5,7-9).
The following prompt is displayed:
Enter Group Number ->
15. Enter a group number for the port(s). Each group on a switch must be
given a unique group number. The range is 1 to 256.
16. If there are unassigned ports in the VLAN, the prompt in Step 13 is
displayed again, showing the unassigned ports. You must repeat
Steps 14 and 15, creating additional groups, until all of the ports in the
VLAN have been assigned to a group.
After creating all of the groups, the following prompt is displayed:
SUCCESS - Press any key to continue.
Press any key to continue.
The new protected ports VLAN and its groups are now active on the
switch.
17. Press any key to return to the Configure VLANs menu.
18. To permanently save your changes, return to the Main Menu and type
S to select Save Configuration Changes.