Allied Telesis AT-S63 - Manual (Page 284)

Chapter 17: Power Over Ethernet
284 Section II: Advanced Operations
Setting the PoE Threshold
This procedure lets you specify a power threshold for the powered devices
that are connected to the switch. If the total power requirements of the
devices exceed the threshold, the switch enters an event in the event log
and sends an SNMP trap to your management workstation. The threshold
is entered as a percentage of the total amount of power on the switch for
the powered devices. At the default setting of 95%, the threshold is 361 W,
which is 95% of 380 W, the maximum power on the AT-924T/POE Switch
for the powered devices.
To configure the PoE threshold, perform the following procedure:
1. From the Main Menu, type 6 to select Advanced Configuration.
2. From the Advanced Configuration menu, type 4 to select Power Over
Ethernet (PoE) Configuration menu. The Power Over Ethernet
Configuration menu is shown in Figure 110.
Figure 110. Power Over Ethernet Configuration Menu
3. From the Power Over Ethernet Configuration menu, type 1 to select
PoE Global Configuration. The PoE Global Configuration menu is
shown in Figure 111.
Figure 111. PoE Global Configuration Menu
Allied Telesis AT-924T/POE - AT-S63
Production Switch
User: Manager 11:20:02 02-Jan-2008
Power Over Ethernet (PoE) Configuration
1 - PoE Global Configuration
2 - PoE Port Configuration
3 - PoE Status
R - Return to Previous Menu
Enter your selection?
Allied Telesis AT-924T/POE - AT-S63
Production Switch
User: Manager 11:20:02 02-Jan-2008
PoE Global Configuration
1 - Power Threshold ................ 95 percent
2 - Maximum Available Power ........ 380W
R - Return to Previous Menu
Enter your selection?