Allied Telesis AT-S63 - Manual (Page 370)

Chapter 21: SNMPv3
370 Section IV: SNMPv3
Modifying a Storage Type
To modify the Storage Type parameter in an SNMPv3 Notify Table entry,
perform the following procedure.
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 321. Or,
from the Main Menu type 5->5->5.
The Configure SNMPv3 Table menu is shown in Figure 126 on page
322.
2. From the Configure SNMPv3 Table menu, type 6 to select Configure
SNMPv3 Notify Table.
The Configure SNMPv3 Notify Table menu is shown in Figure 135 on
page 365.
3. From the Configure SNMPv3 Notify Table menu, type 3 to select Modify
SNMPv3 Table Entry.
The Modify SNMPv3 Notify Table is shown in Figure 136 on page 368.
4. To modify the Storage Type, type 3 to select Set Storage Type.
The following prompt is displayed:
Enter Notify Name:
5. Enter a Notify Name.
The following prompt is displayed:
Enter Storage type [V-Volatile, N-NonVolatile]:
6. Select one of the following storage types for this table entry:
V - Volatile
Select this storage type if you do not want the ability to save an entry in
the SNMPv3 Notify Table to the configuration file. After making
changes to an SNMPv3 Notify Table entry with a Volatile storage type,
the
S - Save Configuration Changes option does not appear on the Main
Menu.
N-NonVolatile
Select this storage type if you want the ability to save an entry in the
SNMPv3 Notify Table to the configuration file. After making changes to
an SNMPv3 Notify Table entry with a NonVolatile storage type, the S -
Save Configuration Changes option appears on the Main Menu,
allowing you to save your changes. Allied Telesis recommends this
storage type.