Allied Telesis AT-S63 - Manual (Page 94)

Chapter 4: SNMPv1 and SNMPv2c
94 Section I: Basic Operations
Enabling or Disabling SNMP Management
To enable or disable SNMP management for the switch, perform the
following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 1 on page 32.
2. From the System Administration menu, type 5 to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 26.
Figure 26. SNMP Configuration Menu
3. From the SNMP Configuration menu, type 1 to toggle the SNMP Status
option between its two settings of Enabled and Disabled. When set to
Disabled, the default, you cannot manage the switch using SNMP.
When set to Enabled, you can manage the switch using SNMP.
A change to the SNMP status is immediately activated on the switch.
4. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Allied Telesis AT-9424Ts - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
SNMP Configuration
1 - SNMP Status ........................ Disabled
2 - Authentication Failure Trap Status ..Disabled
3 - Configure SNMPv1 & SNMPv2c Community
4 - Display SNMPv1 & SNMPv2c Community
5 - Configure SNMPv3 Table
6 - Display SNMPv3 Table
R - Return to Previous Menu
Enter your selection?