Allied Telesis AT-S63 - Manual (Page 525)

AT-S63 Management Software Menus User’s Guide
Section VI: Virtual LANs 525
Modifying a Protected Ports VLAN
Note the following before performing this procedure:
ˆ To modify a protected ports VLAN, you have to recreate it. You must
reselect the uplink port(s) and reassign the ports to the groups. To
make the process easier, Allied Telesis recommends displaying the
details of the VLAN before performing this procedure, and writing down
on paper the current configuration (i.e., uplink port and port to group
assignments). This information will make it easier for you to recreate
the VLAN, with the necessary modifications, when you perform the
procedure. To display a VLAN’s configuration, refer to “Displaying a
Protected Ports VLAN” on page 528.
ˆ To add untagged ports, the ports must be untagged members of the
Default_VLAN or a port-based or tagged VLAN. They can not be
members of another protected ports VLAN.
ˆ An untagged port removed from a VLAN is automatically returned to
the Default_VLAN.
Note
You need to know the VID of a VLAN to modify it. To view VLAN
VIDs, refer to “Displaying a Protected Ports VLAN” on page 528.
To modify a protected ports VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 171 on page 472.
2. From the VLAN Configuration menu, type 3 to select Configure
VLANs.
The Configure VLANs menu is shown in Figure 172 on page 473.
3. From the Configure VLANs menu, type 2 to select Modify VLAN.
The Modify VLAN menu is shown in Figure 174 on page 481.
4. Type 1 to select VLAN ID (VID).
The following prompt is displayed:
Enter new value -> [1 to 4096] ->
5. Enter the VID of the VLAN to be modified.