Allied Telesis AT-S63 - Manual (Page 399)

AT-S63 Management Software Menus User’s Guide
Section IV: SNMPv3 399
ˆ Security Name
ˆ Transport Tag
ˆ Storage Type
In addition, you can display the entries configured with the Configure
SNMPv1 & SNMPv2c Community menu in the Configure SNMPv3
Community Table menu. However, you cannot modify an SNMPv1 &
SNMPv2c Community Table entry with the Configure SNMPv3 Community
Table menu.
There are three functions you can perform with the Configure SNMPv3
Target
Parameters Table menu.
ˆ “Creating an SNMPv3 Community Table Entry,” next
ˆ “Deleting an SNMPv3 Community Table Entry” on page 402
ˆ “Modifying an SNMPv3 Community Table Entry” on page 403
Creating an
SNMPv3
Community
Table Entry
To create an entry in the Configure SNMPv3 Community Table menu,
perform the following procedure.
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 321. Or,
from the Main Menu type 5->5->5.
The Configure SNMPv3 Table menu is displayed Figure 126 on page
322.
2. From the Configure SNMPv3 Table menu, type 9 to select Configure
SNMPv3 Community Table.