Allied Telesis AT-S63 - Manual (Page 498)

Chapter 25: GARP VLAN Registration Protocol
498 Section VI: Virtual LANs
Enabling or Disabling GVRP on a Port
This procedure enables and disables GVRP on a switch port. The default
setting for GVRP on a port is enabled. Only those ports where GVRP is
enabled transmit PDUs.
Note
Allied Telesis recommends disabling GVRP on unused ports and
those ports connected to GVRP-inactive devices for protection
against unauthorized access to restricted areas of your network.
To enable or disable GVRP on a port, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 171 on page 472.
2. From the VLAN Configuration menu, type 6 to select Configure GARP-
GVRP.
The GARP-GVRP menu is shown in Figure 180 on page 496.
3. From the GARP-GVRP menu, type P to select GVRP Port
Parameters.
The GVRP Port Parameters menu is shown in Figure 181.
Figure 181. GVRP Port Parameters Menu
4. From the GVRP Port Parameters menu, type 1 to select Configure
GVRP Port Settings.
Allied Telesis AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
GVRP Port Parameters
1 - Configure GVRP Port Settings
2 - Display GVRP Port Configuration
R - Return to Previous Menu
Enter your selection?