Allied Telesis AT-S63 - Manual (Page 321)

AT-S63 Management Software Menus User’s Guide
Section IV: SNMPv3 321
Configuring the SNMPv3 User Table
This section contains a description of the SNMPv3 User Table and how to
create, delete, and modify table entries. Configure the SNMPv3 User
Table first. Creating this table, allows you to create an entry in an SNMPv3
User Table for a User Name. In addition, this table allows you to associate
a User Name with the following parameters:
ˆ Authentication protocol
ˆ Authentication password
ˆ Privacy protocol
ˆ Privacy password
There are three functions you can perform with the SNMPv3 User Table.
ˆ “Creating an SNMPv3 User Table Entry,” next
ˆ “Deleting an SNMPv3 User Table Entry” on page 325
ˆ “Modifying an SNMPv3 User Table Entry” on page 326
Creating an
SNMPv3 User
Table Entry
To create an entry in the SNMPv3 User Table, perform the following
procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 1 on page 32.
2. From the System Administration menu, type 5 to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 26 on page 94.
3. From the SNMP Configuration menu, type 5 to select Configure
SNMPv3 Table.