Allied Telesis AT-S63 - Manual (Page 433)

AT-S63 Management Software Menus User’s Guide
Section V: Spanning Tree Protocols 433
9 - Root Path Cost
The cost of the path from the current switch to the root switch of the
spanning tree domain. If the current switch is the root switch, root path
cost will be “0”. This value cannot be changed and is only displayed
when RSTP is activated on the switch.
4. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Configuring
RSTP Port
Settings
To adjust RSTP port parameters, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 152 on
page 420.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The RSTP menu is shown in Figure 153 on page 423.
3. From the Spanning Tree Configuration menu, type 3 to select STP
Configuration.
The STP menu is shown in Figure 153 on page 423.
4. From the STP menu, type P to select RSTP Port Parameters.
The RSTP Port Parameters menu is shown in Figure 158.
Figure 158. RSTP Port Parameters Menu
5. Type 1 to select Configure RSTP Port Settings. The following prompt
is displayed:
Starting Port to Configure [1 to 24] ->
6. Enter the number of the port you want to configure. To configure a
range of ports, enter the first port of the range.
Allied Telesis AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
RSTP Port Parameters
1 - Configure RSTP Port Settings
2 - Display RSTP Port Configuration
3 - Display RSTP Port State
R - Return to Previous Menu
Enter your selection?