Allied Telesis AT-S63 - Manual (Page 138)

Chapter 7: LACP Port Trunks
138 Section I: Basic Operations
Modifying an Aggregator
This procedure explains how to modify an aggregator. You can use this
procedure to change the load distribution method of an aggregator or to
add or remove ports. To modify an aggregator, you need to know its
name. To view the names of the existing aggregators, refer to “Displaying
LACP Port and Aggregator Status” on page 141.
Caution
If you will be adding or removing ports from the aggregator, you
should disconnect all network cables from the ports of the
aggregator on the switch before performing the procedure. Adding
or removing ports without first disconnecting the cables can result in
loops in your network topology, which can result in broadcast storms
and poor network performance.
To modify an aggregator, perform the following procedure:
1. From the Main Menu, type 1 to select Port Configuration.
2. From the Port Configuration menu, type 4 to select Port Trunking and
LACP. The Port Trunking and LACP menu is shown in Figure 35 on
page 116.
3. Type 2 to select LACP Configuration. The LACP (IEEE 8023ad)
Configuration menu is shown in Figure 39 on page 132.
4. Type 4 to select Modify Aggregator.
The Modify LACP (IEEE 8023ad) Aggregator menu is shown in Figure
41.
Figure 41. Modify LACP (IEEE 8023ad) Aggregator Menu
Allied Telesis AT-9448T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Modify LACP (IEEE 802.3ad) Aggregator
1 - Aggregator ..................
2 - Adminkey .................... 0x0000
3 - Distribution Mode ........... SRC/DST MAC
4 - Port Range ..................
M - Modify Aggregator
R - Return to Previous Menu
Enter your selection?