Allied Telesis AT-S63 - Manual (Page 327)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: SNMPv3 327
6. Choose one of the following Privacy Protocols:
D -DES
Select this value to make the DES privacy (or encryption) protocol the
privacy protocol for this User Table entry. With this selection,
messages transmitted between the host and the switch are encrypted
with the DES protocol.
N -None
Select this value if you do not want a privacy protocol for this User
Table entry. With this selection, messages transmitted between the
host and the switch are not encrypted.
If you select None, proceed to step 9.
If you select DES, the following prompt is displayed:
Enter Privacy Password:
7. Enter a privacy password of up to 32 alphanumeric characters.
The following prompt is displayed:
Re-enter Authentication password:
8. Re-enter the password.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying the Storage Type
To modify the Storage Type in an SNMPv3 User Table entry, perform the
following procedure.
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 319. Or,
from the Main Menu type 5->5->5.
The Configure SNMPv3 Table menu is shown in Figure 118 on page
320.
2. From the Configure SNMPv3 Table menu, type 2 to select Configure
SNMPv3 User Table.
The SNMPv3 User Table is shown in Figure 119 on page 320.
3. From the SNMPv3 User Table, type 3 to select Modify SNMPv3 Table
Entry.
The Modify SNMPv3 Table menu is shown in Figure 120 on page 324.
4. To change the storage type, type 3 to select Set Storage Type.