Allied Telesis AT-S63 - Manual (Page 483)

AT-S63 Management Software Menus Interface User’s Guide
Section VI: Virtual LANs 483
Modifying a Port-based or Tagged VLAN
Note
To modify a VLAN, you need to know its VID. To view VLAN VIDs,
refer to “Displaying VLANs” on page 487.
To modify a VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 163 on page 474.
2. From the VLAN Configuration menu, type 3 to select Configure
VLANs.
The Configure VLANs menu is shown in Figure 164 on page 475.
3. From the Configure VLANs menu, type 2 to select Modify VLAN.
The Modify VLAN menu is shown in Figure 166.
Figure 166. Modify VLAN Menu
Note
Selection 2, Change GARP VLAN, is described in Chapter 24,
“GARP VLAN Registration Protocol” on page 497. Selection 3,
Change MAC Associations, is explained in Chapter 27, “MAC
Address-based VLANs” on page 535.
4. From the Modify VLAN menu, type 1 to select VLAN ID (VID).
The following prompt is displayed:
Enter new value -> [1 to 4096] ->
Allied Telesis AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Modify VLAN
1 - VLAN ID (VID) ........
2 - Change GARP VLAN
3 - Change MAC Associations
R - Return to Previous Menu
Enter your selection?