Allied Telesis AT-S63 - Manual (Page 53)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 53
Subnet Mask
Subnet mask of the local interface.
Gateway
For AT-9400 Switches that support IPv4 routing, such as the
AT-9424Ts and AT-9448Ts/XP switches, this field displays the IP
address of the next hop of the switch’s default route. The switch uses
the default route when it receives a network packet for routing, but
cannot find a route for it in the routing table. This field will contain
0.0.0.0 if no default route is defined on the switch.
For AT-9400 Switches that do not support IPv4 packet routing, such as
the AT-9424T/GB and AT-9424T/SP switches, this field displays the
default gateway address. This is the IP address of a router interface on
your network. It represents the next hop to reaching a remote network
device, such as a remote management workstation or a syslog server,
when the switch’s local interface and the remote device are on different
subnets. The default value is 0.0.0.0.
Note
For instructions on how to configure the routing interfaces on the
switch, including the local interface, refer to Chapter 28, “Internet
Protocol Version 4 Routing Interfaces” on page 549.
System Up Time
The number of days, hours, minutes, and seconds the switch has been
operational. You cannot change this setting.
Bootloader and Build Date
The version of the bootloader software and the date it was built.
Application and Build Date
The version of the AT-S63 Management Software that the switch is
currently running and the date it was built.
System Name
The name of the switch.
Administrator
The administrator of the switch.
Location
The location of the switch.
Note
To change the system name, administrator, or location, see
“Configuring the Switch’s Name, Location, and Contact” on page 32.
For information about selection H, System Hardware Status, refer to
“Displaying System Hardware Information” on page 55. For