Allied Telesis AT-S63 - Manual (Page 529)

AT-S63 Management Software Menus Interface User’s Guide
Section VI: Virtual LANs 529
6 - Protected Ports
This identifies the VLAN as a protected ports VLAN. This option can
not be changed. To convert a protected ports VLAN into a tagged or
port-based VLAN, you must delete it and recreate it as a tagged or
port-based VLAN.
7. After making the desired changes, type M to select Modify VLAN.
The following prompt is displayed:
Enter Uplink Ports (4 - 12) ->
This prompt lists the ports of the VLAN.
8. Enter the port to function as the uplink port for the VLAN groups. You
can select more than one uplink port.
The following prompt is displayed:
Enter Group Ports (4 - 11) ->
The prompt lists the ports in the VLAN, minus the uplink port specified
in the previous step.
9. Specify the ports of one of the groups of the VLAN. This can be a small
as one port or as many as all the remaining ports of the VLAN. You
can specify the ports of the group individually (e.g., 2,3,5), as a range
(e.g., 7-9), or both (e.g., 2,5,7-9).
The following prompt is displayed:
Enter Group Number ->
10. Enter a group number for the port(s). Each group on a switch must be
given a unique group number. The range is 1 to 256.
11. If there are unassigned ports in the VLAN, the prompt in Step 8 is
displayed again, showing the unassigned ports. You must repeat
Steps 9 and 10, creating additional groups, until all the ports in the
VLAN are assigned to a group.
This prompt is displayed after all the ports of the VLAN are assigned to
a group:
SUCCESS - Press any key to continue.
Press any key to continue.
The modified protected ports VLAN and its groups are now active on
the switch.
12. Press any key to return to the Configure VLANs menu.
13. To permanently save your changes, return to the Main Menu and type
S to select Save Configuration Changes.