Allied Telesis AT-S63 - Manual (Page 157)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 157
The name of the file should now appear following selection 1 in the File
Operations menu. The file name should be followed by “Exist”, which
means that the file exists in the switch’s file system.
If the management software is unable to find the file, it displays:
The specified file was not found on the system.
Check to be sure you entered the name of the file correctly. If
necessary, performing “Listing All Files” on page 165 to verify the
name of the file.
6. Do one of the following:
ˆ To reconfigure the switch using the parameter settings in the
selected active boot configuration file, reset or power cycle the
switch. For instructions, refer to “Rebooting the Switch” on
page 43.
ˆ To overwrite the settings in the configuration file with the switch’s
current settings, return to the Main Menu and type S to select Save
Configuration Changes.
Viewing a Boot
Configuration
File
Use the following procedure to view the contents of a boot configuration
file. (To display the names of the boot configuration files on the switch, see
“Displaying System Files” on page 165.)
To view the contents of a boot configuration file, perform the following
procedure:
1. From the Main Menu, type 5 to select System Administration.
2. From the System Administration menu, type 9 to select System
Utilities.
3. From the System Utilities menu, type 1 to select File Operations.
The File Operations menu is shown in Figure 47 on page 153.
4. From the File Operations menu, type 7 to select View File.
The following prompt is displayed:
Enter file name:
5. Enter the name of the boot configuration file you want to view.