Allied Telesis AT-S63 - Manual (Page 593)

AT-S63 Management Software Menus Interface User’s Guide
Section IX: Management Security 593
3. Type 1 to select Status to enable or disable the web server. To
configure the web server, you must first disable it. Possible settings
are:
Enabled - Enables the web server. This is the default setting.
Disabled - Disables the web server. (To change any of the web server
settings, you must first disable it.)
4. Type 2 to select Mode to set the mode of the web server. The following
prompt is displayed:
Enter Web Server Mode (1 - HTTP, 2 - HTTPS):
[1 to 2] ->
1. Choose one of the following:
1 - HTTP to select the non-secure HTTP mode for the web server. This
is the default value.
2 - HTTPS to select the secure HTTPS mode. This setting activates
the SSL protocol on the web server.
When you choose HTTPS, the following prompt is displayed:
Enter SSL Key ID ->
2. Enter an SSL Key ID.
Enter the ID number of an encryption key on the switch. (To view the
encryption key IDs, refer to “Creating an Encryption Key” on
page 598.) The encryption key and its certificate must already exist on
the switch and the certificate must be in the certificate database.
3. To enable the web server, type 1 to toggle Status to Enabled.
The Web Server Configuration menu is redisplayed. Figure 212 shows
an example of the menu configured for HTTPS.
Figure 212. Web Server Configuration Menu Configured for HTTPS
Allied Telesis AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Web Server Configuration
1 - Status ............................ Enabled
2 - Mode .............................. HTTPS
3 - Port Number ....................... 443
4 - SSL Key ID ........................ 243
R - Return to Previous Menu
Enter your selection?