Allied Telesis AT-S63 - Manual (Page 387)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: SNMPv3 387
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting an
SNMPv3 Target
Parameters Table
Entry
You may want to delete an entry from the SNMPv3 Target Parameters
Table. When you delete an SNMPv3 Target Parameters Table entry, there
is no way to undelete, or recover, the entry.
To delete an entry in the SNMPv3 Target Parameters Table, perform the
following procedure:
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 319. Or,
from the Main Menu type 5->5->5.
The Configure SNMPv3 Table menu is shown in Figure 118 on page
320.
2. From the Configure SNMPv3 Table menu, type 8 to select Configure
SNMPv3 Target Parameters Table.
The Configure SNMPv3 Parameters Table menu is shown in Figure
131 on page 384.
Note
To display a Group Name and its associated parameters from the
Configure SNMPv3 SecurityToGroup Table menu, type N to display
the Next Page and P to display the previous page.
3. To delete an SNMPv3 Target Parameters Table entry, type 2 to select
Delete SNMPv3 Table Entry.
The following prompt is displayed:
Enter Target Parameters Name:
4. Enter a Target Parameters Name.
The following prompt is displayed:
Do you want to delete this table entry?(Y/N):[Yes/No]->
5. Enter Y to delete the SNMPv3 Target Address Table entry or N to save
the entry.
6. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.