Allied Telesis AT-S63 - Manual (Page 377)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: SNMPv3 377
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying the Target Address Timeout
The Target Address Timeout parameter only applies when the message
type is an Inform message. To modify the Target Address Timeout
parameter in an SNMPv3 Target Address Table entry, perform the
following procedure.
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 319. Or,
from the Main Menu type 5->5->5.
The Configure SNMPv3 Table menu is shown in Figure 118 on page
320.
2. From the Configure SNMPv3 Table menu, type 7 to select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Address Table menu is shown in Figure
129 on page 371.
3. From the Configure SNMPv3 Target Address Table menu, type 3 to
select Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Address Table menu is shown in Figure
130 on page 375.
4. To modify the Target Address Timeout, type 3 to select Set Target
Address Timeout.
The following prompt is displayed:
Enter Target Address Name:
5. Enter a previously configured Target Address Name.
This is the name of the SNMP manager, or host, that manages the
SNMP activity on your switch. You can enter a name of up to 32
alphanumeric characters.
The following prompt is displayed:
Enter Timeout (10mS): [0 to 2147483647]-> 1500
6. Enter a timeout value in milliseconds.
When an Inform message is generated, a response from the switch is
required. The timeout value determines how long the switch considers
the Inform message an active message. This parameter applies to