Allied Telesis AT-S63 - Manual (Page 358)

Chapter 20: SNMPv3
358 Section IV: SNMPv3
3-v3
Select this value to associate the Group Name with the SNMPv3
protocol.
The following prompt is displayed:
Do you want to delete this table entry? (Y/N):[Yes/No]->
6. Enter Y to delete this SecurityToGroup entry or N to save the entry.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
SNMPv3
SecurityToGroup
Table Entr y
This section describes how to modify parameters in an SNMPv3
SecurityToGroup Table entry. See the following procedures:
ˆ “Modifying the Group Name” on page 358
ˆ “Modifying the Storage Type” on page 360
Modifying the Group Name
To modify the Group Name in an SNMPv3 SecurityToGroup Table entry,
perform the following procedure.
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 319. Or,
from the Main Menu type 5->5->5.
The Configure SNMPv3 Table menu is shown in Figure 118 on page
320.
2. From the Configure SNMPv3 Table menu, type 5 to select Configure
SNMPv3 SecurityToGroup Table.
The Configure SNMPv3 SecurityToGroup Table is shown in Figure
123.
3. From the Configure SNMPv3 SecurityToGroup Table, type 3 to select
Modify SNMPv3 Table Entry.