Allied Telesis AT-S63 - Manual (Page 204)

Chapter 11: Event Logs and the Syslog Client
204 Section II: Advanced Operations
Working with the Event Logs
This section contains the following procedures:
ˆ “Enabling or Disabling the Event Logs,” next
ˆ “Displaying an Event Log” on page 205
ˆ “Modifying the Event Log Full Action” on page 211
ˆ “Clearing an Event Log” on page 212
ˆ “Saving an Event Log to a File” on page 212
Enabling or
Disabling the
Event Logs
This procedure explains how to enable or disable the event logs on the
switch. If you disable the logs, the AT-S63 Management Software does
not store events in its logs and does not send events to any syslog
servers. The default setting for the event logs is enabled.
Note
Allied Telesis recommends setting the switch’s date and time if you
enable the event logs. Otherwise, event messages will not have the
correct time and date. For instructions, refer to “Setting the System
Time” on page 38.
To enable or disable the event logs, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
2. From the System Administration menu, type 8 to select Event Log. The
Event Log menu is shown in Figure 63.
Figure 63. Event Log Menu
Allied Telesis AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Event Log
1 - Event Logging .......... Enabled
2 - Display Output ......... Temporary (Memory)
3 - Display Order .......... Chronological
4 - Display Mode ........... Normal
5 - Display Severity ....... E, W, I
6 - Display Module ......... All
C - Clear Log
L - Configure Log Outputs
S - Save Log to File
V - View Log
R - Return to Previous Menu
Enter your selection?