Allied Telesis AT-S63 - Manual (Page 281)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 281
When you modify a policy, note the following:
ˆ You cannot change the traffic class ID number.
ˆ To delete a value from a variable so as to leave it blank, select the
variable and then use the backspace key to delete its default value.
ˆ Specifying an invalid value for a parameter that already has a value
causes the parameter to revert to its default value.
7. Type M to select Modify Policy.
Modifications to a policy are immediately activated on the ports where
the policy is assigned.
8. To modify another policy, repeat this procedure starting with step 4.
9. To permanently save your change, return to the Main Menu and type S
to select Save Configuration Changes.
Deleting a Policy
To delete a policy, perform the following procedure:
1. From the Main Menu, type 7 to select Security and Services.
2. From the Security and Services menu, type 6 to select Quality of
Service.
The Quality of Service (QoS) menu is shown in Figure 89 on page 258.
3. From the Quality of Service (QoS) menu, type 3 to select Policy
Configuration.
The Policy Configuration menu is shown in Figure 102 on page 277.
4. From the Policy Configuration menu, type, type 3 to select Destroy
Policy.
The following prompt is displayed:
Available Policy(ies): 0-4
Enter Policy ID : [0 to 255] -> 0
5. Enter the ID number of the policy you want to delete. You can delete
only one policy at a time.
6. Type D to delete the policy.
The policy is deleted from the switch.
7. To delete another policy, repeat this procedure starting with step 4.
8. To permanently save your change, return to the Main Menu and type S
to select Save Configuration Changes.