Configuring stp, Configuring stp bridge settings – Allied Telesis AT-S63 User Manual
Page 420
Chapter 21: Spanning Tree and Rapid Spanning Tree Protocols
420
Section V: Spanning Tree Protocols
Configuring STP
This section contains the following procedures:
”Configuring STP Bridge Settings”, next
“Configuring STP Port Settings” on page 423
“Displaying STP Port Settings” on page 426
“Resetting STP to the Default Settings” on page 427
Configuring STP
Bridge Settings
This section contains the procedure for configuring a bridge’s STP
settings.
Caution
The default STP parameters are adequate for most networks.
Changing them without prior experience and an understanding of
how STP works might have a negative effect on your network. You
should consult the IEEE 802.1d standard before changing any of the
STP parameters.
To configure the bridge settings, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 144 on
page 418.