Allied Telesis AT-S63 - Manual (Page 99)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 99
Modifying a Community String
To modify a community string, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 1 on page 32.
2. From the System Administration menu, type 5 to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 26 on page 94.
3. From the SNMP Configuration menu, type 3 to select Configure
SNMPv1 &SNMPv2c Community.
The Configure SNMPv1 &SNMPv2c Community menu in shown in
Figure 27 on page 96.
4. From the Configure SNMPv1 &SNMPv2c Community menu, type 3 to
select Modify SNMP Community.
The Modify SNMP Community menu is shown in Figure 28.
Figure 28. Modify SNMP Community Menu
This menu lists the current community strings on the switch and their
attributes. For attribute definitions, refer to “Creating an SNMP
Community String” on page 96.
Allied Telesis AT-9424Ts - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Modify SNMPv1 & SNMPv2c Community
Community Name AccessMode Status OpenAcc Manager IP Addr Trap Rec IP
---------------------------------------------------------------------------
Private
Read|Write Enabled Yes
Public Read Enabled Yes
Private Read|Write Enabled Yes
Public Read Enabled Yes
1 - Add Attributes to Community
2 - Delete Attributes from Community
3 - Set Community Access Mode
4 - Set Community Status
5 - Set Community Open Access
U - Update Display
R - Return to Previous Menu
Enter your selection?