Modifying an snmpv3 community table entry – Allied Telesis AT-S63 User Manual
Page 401
AT-S63 Management Software Menus Interface User’s Guide
Section IV: SNMPv3
401
Modifying an
SNMPv3
Community
Table Entry
For each entry in the SNMPv3 Community Table, you can modify the
following parameters:
Community Name
Security Name
Transport Tag
Storage Type
However, you cannot modify the Community Index parameter.
Although you can display the SNMPv1 and SNMPv2c configuration
created with the procedures described in “Creating an SNMP Community
String” on page 96, you cannot modify these Community Table entries
with the SNMPv3 Tables.
See the following procedures:
“Modifying the Community Name” on page 401
“Modifying the Security Name” on page 403
“Modifying the Transport Tag” on page 403
“Modifying the Storage Type” on page 404
Modifying the Community Name
To modify the Community Name parameter in an SNMPv3 Community
Table entry, perform the following procedure:
1. Display the Configure SNMPv3 Table menu by performing steps 1
through 3 in “Configuring the SNMPv3 User Table” on page 319. Or,
from the Main Menu type 5->5->5.
The Configure SNMPv3 Table menu is displayed Figure 118 on page
320.
2. From the Configure SNMPv3 Table menu, type 9 to select Configure
SNMPv3 Community Table.
The SNMPv3 Community Table is shown in Figure 133 on page 398.
3. From the Configure SNMPv3 Community Table, type 3 to select Modify
SNMPv3 Table Entry.