Allied Telesis AT-S63 - Manual (Page 201)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 201
4. From the System Utilities menu, type 2 to select Downloads and
Uploads.
The Downloads and Uploads menu is shown in Figure 54 on page 176.
5. From the Downloads and Uploads menu, type 4 to select Upload a
File.
The following prompt is displayed:
Only TFTP uploads are available for a Telnet access
TFTP Server IP address:
6. Enter the IP address of the TFTP server.
The following prompt is displayed:
Remote File Name:
7. Enter a name for the file for when it is stored on the TFTP server.
When naming a file, be sure to give it the same extension as the
original file name (for example, “.cfg” for a configuration file and “.csr”
for an CA certificate enrollment request.)
The following message is displayed:
Local File Name:
8. Enter the name of the system file on the switch that you want to upload
to the TFTP server. You can specify only one file. You cannot use
wildcards in the file name. If the file is stored on a flash memory card in
the switch, precede the filename with “cflash:”.
The following message is displayed:
Sending the file to Remote TFTP Server - Please wait ...
After the switch has uploaded the system file, the following message is
displayed:
File sent successfully!
The file is now stored on the TFTP server. This completes the
procedure for uploading a file from a remote management session
using TFTP.