Lenze PLC Designer ApplicationTemplate (PLC Designer R3-x) - Manual (Page 111)

Lenze · ApplicationTemplate · 1.3 EN - 04/2013
111
The L_EATP_ApplicationTemplate library
Automatically generated functions
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
11.1 Automatically generated functions
This section contains detailed information on functions that are generated automatically by the
»PLC Designer«. The output values can be found under: ProjectProject information
11.1.1 GetBooleanProperty (automatically generated by »PLC Designer«)
The function provides boolean project information of the library. (Currently no boolean project
information is used).
Inputs
Outputs

Note!
If the project information is changed, the following setting is required:
Call the project information: ProjectProject information .
• Deactivate the "Automatically generate POUs for property access" parameter.
• Click OK to close the project information.
Call the project information again: ProjectProject information .
• Activate the "Automatically generate POUs for property access" parameter.
• Click OK to close the project information.
The changed project information will be available in the project afterwards.

Note!
This function must always be used with the corresponding name area of the related
library. (for instance IOStandard.GetNumberProperty(stKey))
GetBooleanProperty
WSTRING ⎯ stKey GetBooleanProperty ⎯ BOOL
Identifier/data type Information/possible settings
stKey
WSTRING
Key of the project information
Identifier/data type Information/possible settings
GetBooleanProperty
BOOL
Value of the project information