Lenze PLC Designer ApplicationTemplate (PLC Designer R3-x) - Manual (Page 153)

Lenze · ApplicationTemplate · 1.3 EN - 04/2013
153
Application example: Flying saw
Preparation: Modularising the automation system into subfunctions
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
13.1.1 Identifying subfunctions of the machine structure
[13-2] Machine structure divided into subfunctions: Machine modules
13.1.2 Representing subfunctions of the machine structure as machine modules
13.1.3 Representing machine modules in a tree structure
The subfunctions of the machine structure determined previously must be represented in a tree
structure. The tree structure can be seen in the »PLC Designer« as machine structure tree
afterwards.
[13-3] Hierarchy of the machine modules as tree structure
 Infeed unit: Infeed
 Saw blade / cutting: Blade
 Saw carriage / synchronous travel: Slide
 Outfeed unit: Outfeed
Machine module Function
MM 1 Machine control: Machine control module
MM 2 Infeed
MM 3 Flying saw
MM 4 Slide
MM 5 Blade
MM 6 Outfeed