Lenze PLC Designer ApplicationTemplate (PLC Designer R3-x) - Manual (Page 172)

Application example: Flying saw
Error handling: Configuring the error handling
172
Lenze · ApplicationTemplate · 1.3 EN - 04/2013
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Double-click and open:
• Folder A70_MachineModuleSources\ MM_B01_Infeed\ModApp1
• Module application MAP_B01_Infeed_App1
Call the timer, deceleration time: 200 ms
6. Program the error handling.
Add the program line:
Double-click and open:
• Folder A70_MachineModuleSources\
MM_B01_Infeed\ModApp1\Map_B01_Infeed_App1 (FB)\States
• Action S02_Ready
Insert the program line into the Continuous action:
Double-click and open:
• Folder A70_MachineModuleSources\
MM_B01_Infeed\ModApp1\Map_B01_Infeed_App1 (FB)\States
• Action S03_Manual
Insert the program line into the Continuous action:
Double-click and open:
• Folder A70_MachineModuleSources\
MM_B01_Infeed\ModApp1\Map_B01_Infeed_App1 (FB)\States
• Action S10_Fault
Insert the program line into the Continuous action: