Lenze PLC Designer ApplicationTemplate (PLC Designer R3-x) - Manual (Page 44)

Working with the ApplicationTemplate
Mapping the actual machine structure in the »PLC Designer«
44
Lenze · ApplicationTemplate · 1.3 EN - 04/2013
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2. Set the baud rate via the CANbus tab.
Note: The value of the transfer rate set in the »PLC Designer« overwrites any existing
transfer values of the devices (set via »WebConfig«/»Engineer«).
3. In a CANopen network, set the same baud rate for all nodes.
4. Use the Add Device command to extend the control configuration by "CANopen
Manager".