Lenze PLC Designer ApplicationTemplate (PLC Designer R3-x) - Manual (Page 34)

Opening the ApplicationTemplate
Simulation (valid for the ApplicationTemplateCounter)
34
Lenze · ApplicationTemplate · 1.3 EN - 04/2013
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.5 Simulation (valid for the ApplicationTemplateCounter)

How to deactivate the "Watchdog" monitoring:
1. Double-click the A90_Resources folder in the device view.
• Double-click Task configuration TaskHighPriority .
• On the Configuration tab, deactivate the Watchdog option by removing the ;
checkmark:
• Double-click Task configuration TaskMidPriority .
• On the Configuration tab, deactivate the Watchdog option by removing the ;
checkmark:

Note!
In order to be able to use the simulation mode in the "ApplicationTemplateCounter", the
"Watchdog" monitoring must be deactivated (corresponds to the standard setting in the
ApplicationTemplate).
An activated "Watchdog" monitoring results in an error message so that the simulation
mode cannot be activated.