MacDon FD75 OM - Manual (Page 144)

OPERATION
6. Select the GROUP arrow (A). The GROUP
window opens.
Figure 4.184: Combine Display
7. Select HEADER HEIGHT/TILT(A). The PARAMETER
window opens.
Figure 4.185: Combine Display
8. Select LEFT HEADER HEIGHT SEN (A), and then
select the GRAPH button at the bottom of the screen.
The exact voltage is displayed at top of screen.
Raise and lower the header to see the full range of
voltage readings.
9. If the sensor voltage is not within the low and high
limits shown in
Height Sensor Output Voltage Range
– Combine Requirements, page 58 , or if the range
between the low and high limits is insufficient, you
need to make adjustments. For instructions, refer to
Adjusting Voltage Limits, page 60 .
Figure 4.186: Combine Display
169894 130 Revision A