MacDon FD75 OM User Manual
Page 71
Figure 4.34: CA25 Combine Adapter
CA25 Combine Adapters are factory-equipped for Auto Header Height. However, before using the Auto Header
Height feature, you must:
1.
Ensure that the Auto Header Height sensor’s output voltage range is appropriate for the combine.
For more information, refer to
Height Sensor Output Voltage Range – Combine Requirements, page 58
.
2.
Prepare the combine to use the Auto Header Height feature (only applies to some combine models; refer to the
instructions for your combine).
3.
Calibrate the Auto Header Height system so that the combine can correctly interpret data from the height sensor
on the combine adapter (refer to the instructions for your combine).
4.
Once calibration is complete, you are ready to use the Auto Header Height feature in the field. For each combine,
certain operation settings can be used to improve the performance of the Auto Header Height feature (refer to
the instructions for your combine).
NOTE:
If your CA25 Combine Adapter is not equipped to work with a specific combine model, you will need to
install the appropriate combine completion package. That completion package will come with instructions
for installing the Auto Header Height sensor on the combine adapter.
169894
57
Revision A