MacDon FD75 OM - Manual (Page 175)

OPERATION
1. Lower reel, raise header, stop engine, remove key, and engage safety props. For instructions, see the combine
operator’s manual.
2. Open header and remove endshields.
3. At divider storage location, lift divider to disengage
lugs (A) at lower end and then lower it slightly to
disengage pin (B) from endsheet.
Figure 4.243: Stored Crop Divider
4. Position crop divider as shown by locating lugs (A) in
holes in endsheet.
5. Lift forward end of divider until pin (B) at top of divider
engages and closes latch (C).
6. Push safety lever (D) down to lock pin in latch.
Figure 4.244: Crop Divider
A - Lugs B - Pin
C - Latch D - Safety Lever
169894 161 Revision A