MacDon FD75 OM - Manual (Page 154)

OPERATION
8. Move both header float lock levers (A)
down (UNLOCK).
Figure 4.204: Header Float Lock
9. If header is equipped with stabilizer wheels or slow
speed transport wheels, place them in storage position
as follows:
a. On the left wheel assembly, support wheel weight
by lifting slightly with one hand. Pull up on handle
(A) to release lock.
b. Lift wheels to desired height and engage support
channel into slot (B) in upper support.
c. Push down on handle (A) to lock.
Figure 4.205: Left Wheels Shown – Right
Wheels Similar
10. Remove special torque wrench (A) from storage
position at right side of adapter frame. Pull slightly in
direction shown to disengage wrench from hook.
Figure 4.206: Torque Wrench
169894 140 Revision A