MacDon FD75 OM User Manual
Page 79
3.
Press
the
HEADER
button.
The
HEADER
CALIBRATION page displays a warning.
Figure 4.48: Combine Display
4.
Read the warning message, and then press the green
check mark button.
Figure 4.49: Combine Display
5.
Follow the on-page prompts to complete calibration.
NOTE:
The calibration procedure can be cancelled at
anytime by pressing the cancel button in the
bottom, right corner of the page.
While the
header calibration is running, the calibration can
also be canceled by using the up, down, tilt right,
or tilt left buttons on the control handle.
NOTE:
If the combine does not have header tilt installed
or if it is inoperable, you may receive warnings
during calibration. Press the green check mark
if these warnings appear. This will not affect the
AHHC calibration.
Figure 4.50: Combine Display
169894
65
Revision A