MacDon FD75 OM - Manual (Page 90)

OPERATION
6. If applicable, install REEL FORE-BACK.
7. Set HEIGHT SENSITIVITY to desired value. 180 is
recommended as a starting point.
Figure 4.76: Combine Display
8. Install FORE-AFT CONTROL, and HDR FORE-AFT
TILT if applicable.
Figure 4.77: Combine Display
9. Once complete press HEAD2 at bottom of screen.
10. Ensure HEADER TYPE is DRAPER.
NOTE:
If recognition resistor is plugged in to header
harness, you will not be able to change this.
11. Cutting type should be set to PLATFORM.
12. Set appropriate HEADER WIDTH and
HEADER USAGE.
Figure 4.78: Combine Display
169894 76 Revision A