MacDon FD75 OM User Manual
Page 363
Advertising
3.
Raise header and place two 6 in. (150 mm) blocks (A)
under the cutterbar, just inboard of the wing flex points.
4.
Lower header fully,
allowing it to flex into ‘full
frown’ mode.
Figure 6.191: FlexDraper
®
Block Locations
5.
Adjust reel fore-aft position so that back end of
cam disc is at mid–position (‘5’ on the reel arm
indicator decal).
6.
Fully lower the reel.
7.
Shut down engine. Remove key from ignition.
Figure 6.192: Fore-Aft Position
Figure 6.193: Double-Reel
Measurement Locations
169894
349
Revision A
Advertising